Controller test
Checks that the controller is actually sending power to the zone.

Sprinkler Repair & Troubleshooting
A step-by-step test of the controller, wiring, solenoid, valve and line to find why one zone stays off or never stops.
Call or text today615-431-3789Sprinkler Zone Not Working
When one zone stops and the rest keep working, the problem is isolated, which helps. It is usually the controller output, the wire to that valve, the solenoid or the valve itself. A methodical test finds it faster than guessing.
We repair dead and stuck zones across Nashville and Middle Tennessee. We test at the controller, check the wire for continuity, test the solenoid and valve, and then replace or repair the part at fault, so the zone works and stays working.
What you get
Checks that the controller is actually sending power to the zone.
Finds broken or corroded wires between controller and valve.
Tests and replaces the parts that fail most often.
Confirms the zone starts, covers and stops correctly.
The process
We run the zone and measure what reaches the valve.
Wire, solenoid and valve are tested in order.
The faulty part is repaired or replaced and the zone is run.
FAQ
Yes. A failed output can stop one zone. We test the controller first so we do not replace valves unnecessarily.
Lightning can damage controllers, wiring and solenoids. We test each in turn.
Finding a break takes testing, and we use meters and tracing to locate it without digging up the whole yard.
Service areas
From Clarksville to Shelbyville and Dickson to Cookeville, pick your city to see the irrigation work we handle in your part of Middle Tennessee.
Not on the list? Call 615-431-3789. We take projects across Middle Tennessee.
Call, text or send the form. Tell us what your sprinklers are doing or what you want to water, and we will take it from there.